68B-13.008: Gear, Trap Construction, Commercial Trap Marking Requirements, Trap Working Regulations, Trap Transfer
68B-13.010: Stone Crab Trap Limitation Program
PURPOSE AND EFFECT: The purpose of these rule amendments is to make the list of allowable materials for stone crab traps consistent with the list in rule for blue crab traps by allowing the use of galvanized 16 gauge or thinner staples to secure the required degradable panel to the trap and to extend the Stone Crab Advisory Board for an additional three years. The effect of this amendment will be to simplify trap specifications across the stone and blue crab trap fisheries and aid enforcement and to continue collaboration of the Fish and Wildlife Conservation Commission and the stone crab industry on issues related to the fishery.
SUBJECT AREA TO BE ADDRESSED: Stone Crabs.
SPECIFIC AUTHORITY: Art. IV, Sec. 9, Florida Constitution.
LAW IMPLEMENTED: Art. IV, Sec. 9, Florida Constitution.
IF REQUESTED IN WRITING AND NOT DEEMED UNNECESSARY BY THE AGENCY HEAD, A RULE DEVELOPMENT WORKSHOP WILL BE NOTICED IN THE NEXT AVAILABLE FLORIDA ADMINISTRATIVE WEEKLY.
THE PERSON TO BE CONTACTED REGARDING THE PROPOSED RULE DEVELOPMENT AND A COPY OF THE PRELIMINARY DRAFT, IF AVAILABLE, IS: James V. Antista, General Counsel, Fish and Wildlife Conservation Commission, 620 South Meridian Street, Tallahassee, Florida 32399-1600, (850)487-1764
THE PRELIMINARY TEXT OF THE PROPOSED RULE DEVELOPMENT IS:
68B-13.008 Gear, Trap Construction, Commercial Trap Marking Requirements, Trap Working Regulations, Trap Transfer.
(1) No change.
(2) TRAP CONSTRUCTION. No person, firm, or corporation shall transport on the water, fish with, or cause to be fished with, set, or placed, in the harvest of stone crabs, any trap which does not meet the following requirements:
(a) through (b) No change.
(c)1. through 3. No change.
4. Each plastic or wire trap used to harvest stone crabs shall have a degradable panel.
a. A plastic trap shall be considered to have a degradable panel if it contains at least one sidewall with a rectangular opening no smaller in either dimension than that of the throat. This opening must be obstructed with a cypress or untreated pine slat or slats no thicker than 3/4 inch. When the slat degrades, the opening in the sidewall of the trap will no longer be obstructed.
b. A wire trap shall be considered to have a degradable panel if one of the following methods is used in construction of the trap:
(I) The trap lid tie-down strap is secured to the trap at one end by a single loop of untreated jute twine. The trap lid must be secured so that when the jute degrades, the lid will no longer be securely closed.
(II) The trap lid tie-down strap is secured to the trap at one end with a corrodible loop composed of non-coated steel wire measuring 24 gauge or thinner. The trap lid must be secured so that when the loop degrades, the lid will no longer be securely closed.
(III) The trap lid tie-down strap is secured to the trap at one end by an untreated pine dowel no larger than 2 inches in length by 3/8 inch in diameter. The trap lid must be secured so that when the dowel degrades, the lid will no longer be securely closed.
(IV) The trap contains at least one sidewall with a rectangular opening no smaller in either dimension than 6 inches in height by 3 inches in width. This opening must be laced, sewn, or otherwise obstructed by a single length of untreated jute twine knotted only at each end and not tied or looped more than once around a single mesh bar. When the jute degrades, the opening in the sidewall of the trap will no longer be obstructed.
(V) The trap contains at least one sidewall with a rectangular opening no smaller in either dimension than 6 inches in height by 3 inches in width. This opening must be obstructed with an untreated pine slat or slats no thicker than 3/8 inch. When the slat degrades, the opening in the sidewall of the trap will no longer be obstructed.
(VI) The trap contains at least one sidewall with a rectangular opening no smaller in either dimension than 6 inches in height by 3 inches in width. The opening may either be laced, sewn, or otherwise obstructed by non-coated steel wire measuring 24 gauge or thinner or be obstructed with a panel of ferrous single-dipped galvanized wire mesh made of 24 gauge or thinner wire. When the wire or wire mesh degrades, the opening in the sidewall of the trap will no longer be obstructed.
(VII) The trap contains at least one sidewall with a rectangular opening no smaller in either dimension than 6 inches in height by 3 inches in width. The opening may be obstructed with a rectangular panel made of any material, fastened to the trap at each of the four corners of the rectangle by galvanized staples 16 gauge or thinner, rings made of non-coated 24 gauge or thinner wire or single strands of untreated jute twine. When the corner fasteners degrade, the panel will fall away and the opening in the sidewall of the trap will no longer be obstructed.
(3) through (5) No change.
Specific Authority Art. IV, Sec. 9, Fla. Const. Law Implemented Art IV, Sec. 9, Fla. Const. HistoryNew 7-1-00, Amended 7-22-01, 7-15-04,__________.
68B-13.010 Stone Crab Trap Limitation Program.
(1) through (6) No change.
(7) STONE CRAB ADVISORY BOARD. There is hereby established the Stone Crab Advisory Board. Such board shall consider and advise the Commission on the operation of the trap limitation program and any problems in the fishery.
(a) through (f) No change.
(g) Dissolution. On July 1, 2011 2008, the board shall be dissolved.
Specific Authority Art. IV, Sec. 9, Fla. Const. Law Implemented Art IV, Sec. 9, Fla. Const. HistoryNew 7-1-00, Amended 7-22-01, 6-2-02, 7-1-03, 7-15-04,__________.
